NEUTRALÈNE® N 100
SAFE DEGREASING SOLVENT
NON-FLAMMABLE, VOC-FREE, EASILY BIODEGRADABLE
TOTAL EVAPORATION, DOES NOT LEAVE RESIDUAL FILM
USABLE COLD OR HOT
"SPECIAL DEGREASING FOUNTAINS"
|
|
VOC free solvent |
HIGH PERFORMANCE DEGREASING SOLVENT
SPECIAL FOUNTAINS, STRUCTURES, NETWORKS, BINS, RETENTIONS, INDUSTRIAL MAINTENANCE
|
|
NON-FLAMMABLE
Can be used cold or in baths up to 70°C.
Downgrading of ATEX zones.
Very high solvent power KB index greater than 50.
Dielectric breakdown voltage IEC.156
50,000 volts.
Immediate dissolution of tars, crude oil, heavy hydrocarbons,
combustion residues, greases, lubricants.
Formulation additivated for accelerated decantation
in solvent cleaning fountains
SMP OPTIMIZATION
Solvent management plan
(IED DIRECTIVE)
Solvent input / material output balance
Low volatility, consumption reduction.
REMOVAL OF SOLVENT EMISSIONS
|
ODP 0 |
PRP 0 |
Freezing point -20°C. Outdoor storage allowed.
Reduction of industrial risk, loss of operations,
civil liability
(insurance code)
DESCRIPTION
Degreasing solvent, non-flammable, biodegradable, VOC-free, safe cleaning agent with high solvent power specifically developed for use on solvents cleaning fountains, technical fluid based on agri-sourced plant esters that can also be used for all manual degreasing operations with or without mechanical action or in immersion in cold or hot baths up to 70°C.
PRECAUTIONS FOR USE
NEUTRALENE® N 100 does not present any danger, except
in very exceptional cases of accidental ingestion. Refer to the safety data sheet for recommendations for storage, use and disposal after use.
"Dangerous. Respect the precautionary instructions".
TYPICAL PHYSICO-CHEMICAL CHARACTERISTICS
|
CHARACTERISTICS |
STANDARDS |
VALUES |
UNITS |
|
Appearance |
Visual |
Fluid |
- |
|
Colour* |
Visual |
Colourless |
- |
|
Odour |
Olfactory |
Odourless |
- |
|
Density at 25°C |
NF EN ISO 12185 |
805 |
kg/m3 |
|
Refractive index |
ISO 5661 |
1.4465 |
- |
|
Freezing point |
ISO 3016 |
<-20 |
°C |
|
Solubility in water |
- |
Insoluble |
% |
|
Kinematic viscosity at 40°C |
NF EN 3104 |
2.5 |
mm²/s |
|
Acid index |
EN 14104 |
<0.1 |
mg(KOH)/g |
|
Iodine index |
NF EN 14111 |
0 |
gI2/100g |
|
Water content |
NF ISO 6296 |
<0.001 |
% |
|
Residual after evaporation |
NF T 30-084 |
0.0 |
% |
|
Vapour pressure at 20° C |
NF EN 13016-1 |
<0.1 |
hPa |
|
PERFORMANCE CHARACTERISTICS |
|||
|
CHARACTERISTICS |
STANDARDS |
VALUES |
UNITS |
|
KB Index |
ASTM D 1133 |
53 |
- |
|
Evaporation rate |
- |
>4 |
|
|
Surface tension at 20° C |
ISO 6295 |
28 |
Dyne/cm |
|
Breakdown voltage |
IEC.156 |
50,000 |
Volts |
|
Corrosion of copper strip 100h at 40° C |
ISO 2160 |
1a |
Quote |
|
FIRE SAFETY CHARACTERISTICS |
|||
|
CHARACTERISTICS |
STANDARDS |
VALUES |
UNITS |
|
Flash point (closed vessel) |
ISO 2719 |
>100 |
°C |
|
Self-ignition point |
ASTM E 659 |
>230 |
°C |
|
Lower explosive limit |
NF EN 1839 |
0.6 |
% (volume) |
|
Upper explosive limit |
NF EN 1839 |
6.5 |
% (volume) |
|
Content of explosive, oxidizing, flammable, highly or extremely flammable substances |
CLP Regulation |
0 |
% |
|
TOXICOLOGICAL CHARACTERISTICS |
|||
|
CHARACTERISTICS |
STANDARDS |
VALUES |
UNITS |
|
Anisidine index |
NF ISO 6885 |
<1 |
- |
|
Peroxide index |
NF ISO 3960 |
<1 |
meq(O2)/kg |
|
TOTOX (anisidine index+2x peroxide index) |
- |
<3 |
- |
|
Content of CMR, irritants, corrosives substances |
CLP Regulation |
0 |
% |
|
Residual methanol content from transesterification |
GC-MS |
0.0 |
% |
|
Emissions of hazardous compounds, CMR, irritants, corrosive |
GC-MS |
0 |
% |
|
ENVIRONMENTAL CHARACTERISTICS |
|||
|
CHARACTERISTICS |
STANDARDS |
VALUES |
UNITS |
|
Biodegradability |
OCDE 301 A |
>80, >90 |
% |
|
Vapour pressure at 20° C |
- |
<0.1 |
hPa |
|
VOC content (Volatile Organic Compounds) |
- |
0 |
% |
|
Sulphur content |
GC MS |
0 |
% |
|
Benzene content |
ASTM D6229 |
0 |
% |
|
Total halogen content |
GC MS |
0 |
% |
|
Chlorinated solvents content |
- |
0 |
% |
|
Aromatic solvent content |
- |
<0.01 |
% |
|
Substances dangerous for the environment content |
CLP Regulation |
0 |
% |
|
Content of compounds with PRP |
- |
0 |
% |
|
Content of compounds with ODP |
- |
0 |
% |
|
Carbon footprint, life cycle analysis. |
ISO 14040 |
1.55 |
Kg Carbon equivalent |
|
ADDITIONAL CHARACTERISTICS |
|||
|
CHARACTERISTICS |
STANDARDS |
VALUES |
UNITS |
|
Aniline point |
ASTM D 611 |
80 |
°C |
|
Bioaccumulation n-octanol water sharing index |
OCDE 107 |
<3 |
logKow |
|
Effect on water classification |
WGK |
1 |
Class |
PRESENTATIONS
|
Container GRV 1000 L
|
Drum 200 L
|
Can 20 L
|
METHODS OF USE
 |
 |
|
Degreasing rag |
Degreasing with brush |
|
|
|
|
Low pressure sprayers with water rinsing |
Solvent fountains |
|
|
|
|
Ultrasonic tanks |
Hot and cold immersion tanks |
 |
 |
| Rotating or translating basket | Washing machines A3 |
